USC PS10 Operator's Manual page 35

3. Seed Per Unit: Selecting the grey box allows the operator to enter what the seed
per unit is for the product the pump is going to apply chemical to. This will aid in
any SCU based chemical application. Seed Per Pound (Seed per Kilogram in
metric) is only visible while "Direct Translate" and "Manual (Percent) Mode" is not
enabled.
4. Batch Time: Selecting this grey box allows the operator to enter how long the
pump will run when in auto, after the auxiliary signal comes on. If the auxiliary
signal comes off before the timer has completed, the timer will reset. Once the time
is met, the pump will stop running until the auxiliary signal is turned off and back on
again. This option is only available while "Batch Mode" is enabled.
5. Treat By SCU/min: Selecting this check box allows the operator to switch from
entering the target treating rate by SCU/min or by lb/min (or kg/min if in metric).
6. Batch Mode: Selecting this check box allows the operator to turn batch mode off or
on. Batch mode allows the operator to only run the pump for a desired amount of
time while in auto after the auxiliary signal turns on.
7. Manual Batch Mode: Selecting this check box allows the operator to manually
enable batch mode to begin by pressing the Start Batch button on the Main screen
without the need of an auxiliary signal.
8. Direct Translate: Selecting this check box allows the operator to enable direct
translate mode. This mode takes away treater based option, and allow the operator
to enter a requested flow rate by oz/min or mL/min in metric.
9. Manual (Percent) Mode: Selecting this check box allows the operator to enable
manual mode. Manual mode runs the pumps motor at a % motor speed instead of
trying to achieve a targeted application or flow rate.
PUMP STANDS PS10
Utilities Page
Page 35