Utilities Page - USC PS10 Operator's Manual

The Pump Calibration Pop-Up is accessible from the HOA screen of the PS10 pro-
gram.
1. Current Ratio Current calibration ratio of the chemical being used for the calibra-
tion runs. This entry is visible when the pump stand is configured as a flow meter
pump.
2. Calculated Ratio: Calibration ratio calculated based off the calibration tube entry
and pump totalizer. The program will use the calibration tube amount and the pump
internal totalizer amount to calculate a new calibration ratio for the chemical. This
entry is visible when the pump stand is configured as a flow meter pump.
3. Update Ratio Button: This button updates the chemical with the newly calculated
density. This entry is visible when the pump stand is configured as a flow meter
pump.
1
2
3
4
1. Target Treating Rate: Selecting the grey box allows the operator to enter the
target treating rate in either lb/min (kg/min if in metric) or SCU/min depending on
whether "Treat by SCU/min" check box is selected is selected. There is also a
display that shows what lb/min (kg/min if in metric) or SCU/min depending on the
"Treat by SCU/min" check box. Target Treating Rate is only visible while "Direct
Translate" and "Manual (Percent) Mode" is not enabled.
2. Seed Per Pound: Selecting the grey box allows the operator to enter what the
seed per pound (or seed per kilogram if in metric) is for the product the pump is
going to apply chemical to. This will help aid in any SCU based chemical
application. Seed Per Pound is only visible while "Direct Translate" and "Manual
(Percent) Mode" is not enabled.
Page 34
PUMP STANDS PS10

Utilities Page

5
6
7
8
9