Startup And Use; Startup; Initial Check - Vaisala K-PATENTS PR-23 Series Instruction Manual

5 Startup and use

5 Startup and use

5.1 Startup

5.1.1 Initial check

1. Check the wiring, Section 3.3, "Electrical connections".
2. Connect the power. The Power indicator light (Figure 3.5) and the screen should
light up within a few seconds.
3. The Main display should come up on the display, Figure 5.1.
Main display for two sensors
Main display for single sensor,
concentration and temperature
Figure 5.1 Main display alternatives
4. In case the display shows a row of dashes, there is no corresponding sensor (for
example in Figure 5.1, upper left, there's no sensor A, only sensor B is connected).
The diagnostic message is for that sensor
5. Check the serial number of the sensor at the upper right corner in the display.
Main display for single sensor,
concentration only
Main display for single sensor,
concentration and bar graph
.
NO SENSOR
31