Troubleshooting; Error Messages / Operating State (Led Display) - HBM PMX Operating Manual

Troubleshooting

13 Troubleshooting
Before actually starting to measure, you should check your system.

13.1 Error messages / operating state (LED display)

For the system to be ready for measurement, the LEDs on the basic device
and modules must indicate the states described in Sections 7.1.1 to 7.1.3 and
Section 8.1.
If this is not the case, follow the instructions under "Remedy" in the tables
below.
SYS LED (1):
LED Status
On
green
Off
On
yellow
Flashing
Flashing
red
On
A3257−2.0 en/de/fr
Significance
Voltage supply available
Voltage supply off
Device is booting
Factory settings not OK
Serious internal error
Firmware update ongoing
153
Remedy
−
Check the vol-
tage supply
Send in the de-
vice
Check the moun-
ting of the
plug-in card and
replace if ne-
cessary