CDVI DIGIWAY Plus Manual page 39

Inwards and outwards door operator, door automation

Hide thumbs Also See for DIGIWAY Plus:

Table of Contents

6] MAINTENANCE

An automatic door, installed with the DIGIWAY Plus operator, needs periodic checks (at

least every 12 months) as listed in the following points:

1) Check the door balancing and the functionality of the hinges;

2) Sliding arm

Sliding arm: :

2A) Check the fifixing solidity of the sliding guide to the door and its horizontal

alignment;

2B) Check the flfluency of the sliding block;

2C) Check drive shaft bolt is tight;

2D) Check the correct coupling arm-motor shaft (solidity of the driving pins;

2E) Clean the sliding guide. DO NOT LUBRICATE AS THIS MAY CAUSE DEBRIS TO

STICK AND RESULT IN FRICTION OF THE SLIDING BLOCK.;

3) Articulated arm:

Articulated arm:

3A) Check the fifixing of the bracket to the door;

3B) Check the solidity of the articulated arm pivot;

3C) Check drive shaft bolt is tight;

3D) Check the solidity of the adjustable forearm where it fixes the door (2 screws

M5x12);

4) Check the fixing of the motor to the backplate and the backplate to the wall;

5) Check the absence of frictions through the run of the door;

6) Check of the functionality of the peripherals (radar, electrolock or magnet);

7) In the case of double door with overlapping, check the correct synchronization of the

2 leaves;

8) Possible replacement of the battery if the LED LP indicates this.

DIGIWAY Plus

Inward or Outward Door Operator

Table of Contents

Show Quick Links

Table of Contents