CDVI DIGIWAY Plus Manual page 33

EN
4] DOUBLE DOOR CONFIGURATION 4] DOUBLE DOOR CONFIGURATION
The double door configuration applies to both the types DWPD102X (not available in The double door configuration applies to both the types DWPD102X (not available in
the UK) and DWPS102X. the UK) and DWPS102X.
For the types DWPD, for which a central profile is provided, it is necessary to install For the types DWPD, for which a central profile is provided, it is necessary to install
a back plate which ensures perfect alignment between the profiles and 2 lateral back a back plate which ensures perfect alignment between the profiles and 2 lateral back
plates in place of the regular single door back plate. Follow the instructions below for plates in place of the regular single door back plate. Follow the instructions below for
the mechanical fixing of the structure (Part I: mechanical fixing). the mechanical fixing of the structure (Part I: mechanical fixing).
In case of 2 single standard operators (type DWPS102X) to drive a double door, make In case of 2 single standard operators (type DWPS102X) to drive a double door, make
the mechanical fixing by following the regular procedure for each single door. the mechanical fixing by following the regular procedure for each single door.
• • PART I: Mechanical fixing PART I: Mechanical fixing
• • PART II: Electrical connections PART II: Electrical connections
• • PART III: Final PART III: Final Set-up
Part I : Mechanical fixing Part I : Mechanical fixing
1. Backplate fixing 1. Backplate fixing
• • Locate the best position for the central back-plate, locating the centre of the plate Locate the best position for the central back-plate, locating the centre of the plate
with the centre of the double door; with the centre of the double door;
• • Mark the position of the holes for the plugs provided; Mark the position of the holes for the plugs provided;
• • Make the holes and insert the plugs provided; Make the holes and insert the plugs provided;
• • Pass the power supply cable through the central hole of the back-plate; Pass the power supply cable through the central hole of the back-plate;
• • Fix the central back-plate by using the screws and the plugs provided ensuring it is Fix the central back-plate by using the screws and the plugs provided ensuring it is
at perfect level. at perfect level.
• • Couple the side back-plates on each side and locate the position of the oval holes. Couple the side back-plates on each side and locate the position of the oval holes.
• • Make the holes and insert the plugs Make the holes and insert the plugs
• • Fix the side back-plates with the screws provided. Fix the side back-plates with the screws provided.
2. Central profile fixing 2. Central profile fixing
Fix the back central profile with the side caps with the 4 screws M6x14 provided on the Fix the back central profile with the side caps with the 4 screws M6x14 provided on the
central back-plate; central back-plate;
Inward or Outward Door Operator
Set-up
DIGIWAY Plus
33