CDVI DIGIWAY Plus Manual page 13

EN
Parameter
A A
B B
A - B A - B
C C
L1 L1
L2 L2
L3 L3
The Articulated Arm is designed for push applications, outward opening The Articulated Arm is designed for push applications, outward opening
doors. doors.
1) 1) Using the dimensions of the motor and the template provided (see inside of the Using the dimensions of the motor and the template provided (see inside of the
box sleeve) locate the fixing positions and cable holes; box sleeve) locate the fixing positions and cable holes;
2) 2) Make sure the articulated arm bracket fall in the corrst psoition referring to the Make sure the articulated arm bracket fall in the corrst psoition referring to the
lower diagram on page 12; lower diagram on page 12;
3) 3) Make 6 holes diameter Ø 8 mm and insert the 6 rawl plugs provided; Make 6 holes diameter Ø 8 mm and insert the 6 rawl plugs provided;
4) 4) Fix the plate to the wall using the screws provided; Fix the plate to the wall using the screws provided;
5) 5) Fix the motor to the mounting plate with the M6 x 14 bolts provided; Fix the motor to the mounting plate with the M6 x 14 bolts provided;
6) 6) Secure the articulated arm bracket to the door reffering to distance A of the table Secure the articulated arm bracket to the door reffering to distance A of the table
above; above;
7) 7) Attach the articulated arm to the drive shaft using the M6 fixing bolt provided; Attach the articulated arm to the drive shaft using the M6 fixing bolt provided;
8) 8) If distance L3 is larger (see above) an optional extension shaft can be used, If distance L3 is larger (see above) an optional extension shaft can be used,
available in 30mm, 55mm and 80mm; available in 30mm, 55mm and 80mm;
9) 9) Optional extension shaft: Fix the arm to the drive shaft using the M6 bolt provided Optional extension shaft: Fix the arm to the drive shaft using the M6 bolt provided
with the extension; with the extension;
10) 10) Check full free movement whilst in free mode; Check full free movement whilst in free mode;
11) 11) Make all electrical connections; Make all electrical connections;
12) 12) Apply power; Apply power;
13) 13) Follow the "Getting Started" procedure Follow the "Getting Started" procedure; ;
14) 14) Connect the Ground wire to the cover terminal and fix the cover. Connect the Ground wire to the cover terminal and fix the cover.
Connect the equipment to the Mains power using the appropriate cable (3 x 1,5mm Connect the equipment to the Mains power using the appropriate cable (3 x 1,5mm
passing it through the rear opening of the profifile and the backplate and avoiding being passing it through the rear opening of the profifile and the backplate and avoiding being
too tight and touching sharp edges. At the end of the installation, connect the ground too tight and touching sharp edges. At the end of the installation, connect the ground
(earth) cable provided from the control PCB to the push on connector on the cover. (earth) cable provided from the control PCB to the push on connector on the cover.
Inward or Outward Door Operator
Speed Power
(mm) (mm)
410 410 430 430
270 270 360 360
140 140 70 70
40 40
55 - 195 55 - 195
371 371
43 43
DIGIWAY Plus
Description
Door hinge – door bracket distance Door hinge – door bracket distance
Door hinge – motor axis distance Door hinge – motor axis distance
Motor axis – door bracket distance Motor axis – door bracket distance
Bracket holes distance Bracket holes distance
Door jamb width Door jamb width
Distance wall - articulation Distance wall - articulation
Distance motor shaft-door bracket Distance motor shaft-door bracket
), ),
2 2
13