CDVI DIGIWAY Plus Manual page 31

EN
MENU MAIN
SERVICE
NOTES NOTES
(1) Partial counter value; (1) Partial counter value;
(2) Threshold : is the number of cycles after which the unit starts to give the Service (2) Threshold : is the number of cycles after which the unit starts to give the Service
Request message: the main LED flashes RED SLOWLY. Setting this requires entering the Request message: the main LED flashes RED SLOWLY. Setting this requires entering the
correct 4-digit System Password. If Threshold=0 (factory setting) the main LED never correct 4-digit System Password. If Threshold=0 (factory setting) the main LED never
changes colour. changes colour.
(3) Resets the partial counter value: it has to be reset after the maintenance intervention (3) Resets the partial counter value: it has to be reset after the maintenance intervention
and resets the main LED to solid GREEN. and resets the main LED to solid GREEN.
This requires the 4-digit system password to be entered. This requires the 4-digit system password to be entered.
(4) Changing the system password: FACTORY VALUE = 1111 (4) Changing the system password: FACTORY VALUE = 1111
To change the password requires the default or current password to be entered. When To change the password requires the default or current password to be entered. When
changing the password, the new password must re-entered to confirm. changing the password, the new password must re-entered to confirm.
Information Information
Information
Display
In EXPERT mode all the main parameters of the motion will be displayed according to In EXPERT mode all the main parameters of the motion will be displayed according to
the following diagram (see next page): the following diagram (see next page):
Information
SW Release
Information
Counter
Inward or Outward Door Operator
(1) (1)
SERVICE
COUNTER
(2) (2)
SERVICE
THRESHOLD
(3) (3)
SERVICE
RESET COUNTER
(4) (4)
SERVICE
CHANGE PASSWORD
Display
Expert / Normal
WadoPlus v2.0a
dd/mm/yyyy
Counter
00000
DIGIWAY Plus
COUNTER
0
PASSWORD
1111
PASSWORD
1111
PASSWORD
1111
You can change the information displayed on the You can change the information displayed on the
LCD by setting the operating mode EXPERT or LCD by setting the operating mode EXPERT or
NORMAL NORMAL
Gives the SW release number and date. Gives the SW release number and date.
The absolute counter logs each cycle of the door The absolute counter logs each cycle of the door
(OPENING + CLOSING). Its value can be reset by (OPENING + CLOSING). Its value can be reset by
the factory only. the factory only.
THRESHOLD
0500
CONFIRM SERVICE
RESET COUNTER?
NEW PASSWORD
0000
CONF PASSWORD
0000
31