CDVI DIGIWAY Plus Manual page 22

ATTENTION: Any change carried out requires a complete cycle (open, pause, ATTENTION: Any change carried out requires a complete cycle (open, pause,
close) or a system reset to be implemented. close) or a system reset to be implemented.
STEP III: DOOR CALIBRATION [SINGLE LEAF]
DIGIWAY Plus is equipped with an innovative software which fits the internal parameters DIGIWAY Plus is equipped with an innovative software which fits the internal parameters
to the door characteristics. The calibration sets the door travel limits and launches a to the door characteristics. The calibration sets the door travel limits and launches a
special 5 cycle-routine for the automatic detection of the door characteristics. special 5 cycle-routine for the automatic detection of the door characteristics.
For the calibration follow the next steps: For the calibration follow the next steps:
NOTE: Before proceeding with the calibration check the connection of the battery red/
black cable to the main board and disconnect temporarily any lock if connected, Make
sure any door latch is retracted to allow clear operation of the door movement.
Action Action
1 1 Set the EXTERNAL SWITCH in posi-
tion '0' '0' = DOOR FREE
Select Door Calibration from the Main
2 2
Manu and press OK
Select Door Limits from the submenu
3 3
of Door Calibration and press OK
4 4
CLOSE THE DOOR COMPLETELY
and press OK
5 5 OPEN THE DOOR COMPLETELY and
press OK (*)
6 6
Select Autocalibration from the Door
Calibration Menu and press OK
22
DIGIWAY Plus
Inward or Outward Door Operator
(*) If this set is not followed, the software will give a warning.
(*)
Display Display
Door Calibration
Door Calibration
Door Limits
Set Door Limits
Wizard
Close Door
Then Press OK
Open Door
Then Press OK
Thank You
Door Calibration
Door Limits
Door Calibration
Autocalibration
Autocalibration
Wizard
Proceed with
Autocalibration?
EN