CDVI DIGIWAY Plus Manual page 23

EN
Press OK: the door begins 5 cycles of
7 7
opening and closing until asking for
SAVE
8 8
Press OK. The calibration cycle is
over. The door remains open
Set the EXTERNAL SWITCH in position
9 9
'I' = AUTOMATIC. The door closes and
the calibration is completed.
CURRENT CALCULATION CYCLES CURRENT CALCULATION CYCLES
At the end of the door calibration, the door will operate normally. At the end of the door calibration, the door will operate normally. However, to complete
the calibration the system needs 2 more complete cycles to calculate the 2 currents the calibration the system needs 2 more complete cycles to calculate the 2 currents
(called "i" and "I") necessary for obstacle management. Until the 2 cycles are completed, (called "i" and "I") necessary for obstacle management. Until the 2 cycles are completed,
the external LED LP will blink RED. the external LED LP will blink RED. During the 2 cycles, before the completion of this
calculation, if the door meets an obstacle, the obstacle sensitivity used will be the calculation, if the door meets an obstacle, the obstacle sensitivity used will be the
factory value, which may not match the door motion characteristics, therefore: factory value, which may not match the door motion characteristics, therefore:
It is highly recommended to ensure the door completes these 2 cycles without It is highly recommended to ensure the door completes these 2 cycles without
any interruption. When completed, the external LED will illuminate Green, and any interruption. When completed, the external LED will illuminate Green, and
the door calibration is completed. the door calibration is completed.
ADJUSTMENTS ADJUSTMENTS
The maximum speed, the torque and the pause time are automatically calculated by The maximum speed, the torque and the pause time are automatically calculated by
the system during door calibration. the system during door calibration.
If there is a requirement to change any of these settings enter the sub menu 'Main If there is a requirement to change any of these settings enter the sub menu 'Main
Functions'. See following table for the explanation of the parameters. Functions'. See following table for the explanation of the parameters.
Each parameter can be adjusted using the keyboard buttons or transmitter keys. Each parameter can be adjusted using the keyboard buttons or
Open Speed
|||||||||||||||||....................
To increase the value press the UP key To increase the value press the UP key
To decrease the value press the DOWN key To decrease the value press the DOWN key
Press OK to confirm. Press OK to confirm.
Press ESC to exit without saving. Press ESC to exit without saving.
A bar will appear on the display, proportional to the value and the numeric A bar will appear on the display, proportional to the value and the numeric
value of the parameter. value of the parameter.
Inward or Outward Door Operator
STEP IV : ADJUSTMENTS
During the 2 cycles, before the completion of this
45%
DIGIWAY Plus
Closing ...
Measure 1/5...
Tm= XX,X V= XX
Save ?
....C...........................
P=000,0 V=00,0
UP UP
ESC ESC
DOWN DOWN
Warning: whilst the
Digiway is going trough its
5 learning cycles, it can be
dangerous to pass through
the door as it opens very
quickly.
However, to complete
transmitter keys.
ESC ESC
DOWN DOWN
UP UP
23