Thermo Scientific HyPerforma DS 300 User Manual page 32

Chapter 2 | Setup and operating information
Figure 2.22. Inserting the
bearing port into the motor
mount
Figure 2.23. Securing
the drum and dolly to the
positioner with the strap
Thermo Scientific
Note: When lining up the bearing port with the receiver of the
motor mount block, do not twist the BPC in the drum. Rotate the
drum and dolly, instead.
13. Ensure that the drain line and support collar are positioned
correctly in the drum, if applicable.
14. Remove the protective packaging from the lines at the top of the
BPC.
15. If your unit is equipped with the optional drum positioner, use it to
secure the drum and dolly in place with the supplied strap (Figure
2.23).
HyPerforma DS 300 Single‑Use Mixer User's Guide | 29