Table of Contents
Advertisement
MX10003 3D Universal Edge Router Quick Start
Connecting the Router to a Console Device
12
Table 1: Out-of-Band Management Port on the RCB
Callout (See Figure 9)
2
To use a system console to configure and manage the router, connect it to the appropriate
port on the RCB interface. The console port is used to connect a laptop or console
CON
terminal to configure the router (see
console port accepts a cable with an RJ-45 connector. One serial cable with an RJ-45
connector and a DB-9 connector is provided with the router.
NOTE:
Use shielded CAT5e cable for connecting the
in RCB.
To connect a management console:
Turn off power to the console device.
1.
Plug the RJ-45 end of the serial cable (see
2.
the RCB interface.
Plug the female DB-9 end into the device's serial port.
3.
NOTE:
For console devices, configure the serial port to the following values:
Baud rate—9600
Parity—N
Data bits—8
Stop bits—1
Flow control—none
Figure 11: Console and Auxiliary Cable Connector
Label
Description
Dedicated management channel for
MGMT
device maintenance. It is also used by
system administrators to monitor and
manage the router remotely.
Figure 12 on page 13
Figure 11 on page
and
Figure 13 on page
13). The
and
ports
CON
MGMT
12) into the
port on
CON
Copyright © 2017, Juniper Networks, Inc.
Advertisement
Table of Contents
