Table of Contents
Advertisement
MX10003 3D Universal Edge Router Quick Start
16
Locate power cords that have a plug appropriate for your geographical location. For
1.
more information, see the MX10003 3D Universal Edge Router Hardware Guide at
http://www.juniper.net/techpubs/
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
2.
ESD points on the chassis.
Connect the power cord to the power supply.
3.
Insert the power cord plug into an external AC power source receptacle.
4.
NOTE:
Each power supply must be connected to a dedicated AC power
feed and a dedicated customer-site circuit breaker. We recommend that
you use a dedicated customer-site circuit breaker rated for either
15 A (110 VAC) minimum or 10 A (220 VAC) minimum, or as required by
local code.
Fasten the cord retainer by lowering the clip over the cord and pushing the cord into
5.
the adjustment nut of the cord retainer. Rotate the nut until it is tight against the base
of the cord (see
Figure 14 on page
Dress the power cord appropriately. Verify that the power cord does not block the air
6.
exhaust and access to router components, or drape where people could trip on it.
Repeat Step
1
through Step
7.
Switch the AC switch on each power supply to the on position (
8.
status LED on each power supply faceplate. If an AC power supply is correctly installed
and functioning normally, the status LED lights green steadily.
If the status LED indicates that the power supply is not functioning normally, repeat
the installation and cabling procedures.
.
17).
6
for the remaining power supply.
Copyright © 2017, Juniper Networks, Inc.
) and observe the
I
Advertisement
Table of Contents
