Step 6: Install The Air Filter Unit - Juniper MX10003 Quick Start Manual

Step 6: Install the Air Filter Unit

Copyright © 2017, Juniper Networks, Inc.
Figure 15: Connecting a DC Power Cable to an MX10003 DC Power Supply
The air filter unit is installed on the cable management brackets. Before installing the air
filter unit, ensure that the cable management brackets are already installed on the front
of the router.
To install the air filter:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Ensure that the air filter unit is right side up.
2.
Grasp the air filter unit and slide into the rails on the cable management brackets until
3.
it stops (see Figure 16 on page
management brackets.
Figure 16: Installing the Air Filter
19). The air filter unit fits snugly on the cable
Step 6: Install the Air Filter Unit
19