Table of Contents
Advertisement
16.3 Software updates
The major changes for each software version are given in below.
NOTE!: Wide Speedlanes with the spring unit, must use one of the software versions A18-A19.1.
Wide Speedlanes without the spring unit, must use one of the software versions A17-A17.4.
Software version Major changes
A11
A12
A13
A14
A15
A16
A17
A17.1
A17.2
A17.3
A17.4
A18
A18.1
A18.2
A18.3
A18.4
A19.1
Please note that when updating the software in the Speedlane 900 the old version is completely
overwritten by the new version. This can only be done in case the current software does not
contain custom functionality. Otherwise 'custom' software will be overwritten and customer specific
settings need to be set again.
Page:
74
Version:
2014/11
Edition:
SL900 -OIM - USA
Intruder alarm (partial), no buzzer in zone B.
High security (always closing) is no longer available.
Improved free in/out, gate goes open directly after an authorization, even if it is
halfway closing.
When standing in the safety zone while giving an authorization, the gate will open
after stepping out of the safety zone
Software improved. Free in/out door wings cannot close while standing in the
gate
Default setting card reader mode now 1xRead signal and 1xBooking signal. Also
available 1xBooking in and 1xBooking out.
High security in combination with free out is improved. After stepping out of the
gate after free in/out passing the gate closes directly.
Program was cleaned up. Free out functionality is improved
Program is stable
Authorization signalling did not become green with fire alarm.
In high security mode it was possible to sneak in from the opposite side, the gate
stays open but still works.
Free in bug was solved. Mostly free out is used.
This version is used for any wide gate without the spring construction
After malfunction an auto reset is done when safety sensors (1, 7, 8, 9, 15 and
16) are free
For any wide gate in combination with the spring construction. Maximum retry to
close is 5 times. Speed change for all wide gates, closing speed 1 is not available
anymore for other types. Solved the bug that authorization light goes out and no
authorizations are possible when someone passes the gate and stays in the last
sensors of the gate until it is closed. The authorization lights will not go out, the
red cross stays on.
While opening an entry passage is started, it is not possible to close the gate by
an intruder on the exit side
After malfunction an auto reset is done when safety sensors (1, 7, 8, 9, 15 and
16) are free
Multibeam read out added to the program
Authorization signalling is changed, in combination with sensor open mode a
cross was shown after 2 or more authorizations
Frequency Inverter can be selected, this makes it possible to use new software
versions with the older Omron inverter.
Software updates
OIM - Manual
Speedlane 900
Hide quick links:
Advertisement
Table of Contents
