Field 1 - BOON EDAM Speedlane 900 Operation Installation And Maintenance

When this program is started, the following screen is shown.
To make a communication connection between the computer and the microprocessor, all the fields
in block 1 must be filled in. When these adjustments are not filled in correctly, there will be no
communication possible between the computer and the microprocessor.

11.1.1 Field 1

First the communication port must be selected, click on the arrow on the right side of the COM-Port
field. Select COM1.
Set the Baud Rate to 19200 in the same way.
Select the device by clicking on the arrow on the right side of the Device field. Select XA-G49.
Set the oscillator frequency to 11 MHz by typing 11 in the Oscillator Freq (MHz) field.
The communication settings are now ready.
Page: 58
Version: 2014/11
Edition: SL900 -OIM - USA
OIM - Manual
Speedlane 900