Receiver - BOON EDAM Speedlane 900 Operation Installation And Maintenance

7.2.2 Receiver

The receiver and communication module is located in the master unit.
RS458 SW1
The MBR is equipped with 4 DIP-switches. These switches allow for choosing the operating mode
of the RS485 communication.
For the Speedlane 900 the DIP-switches of the MBR must be in the following configuration:

Switch 1

Switch 2

Switch 3

Switch 4
If a second Multibeam is mounted in a long or high Speedlane 900 the 4 DIP-switches of the second
MBR must be set in the following configuration:

Switch 1

Switch 2

Switch 3

Switch 4
The RS485 is directly connected to the Microcontroller Board. Beside the RS485 this connection also
takes care of the power supply (24VDC) of the complete Multibeam system.
On the receiving module 16 red LED's provide the beams status. Each beam has its own LED. When
a beam is interrupted this LED will lit red. In case of a broken transmitter or receiver this same LED
will light up.
Page: 40
Version: 2014/11
Edition: SL900 -OIM - USA
To Emmit LEDS
Receiving and communication module
= ON
= ON
= OFF
= OFF
= ON
= ON
= OFF
= ON
Flat cable print
OIM - Manual
Speedlane 900