To Do A Check Of The Parallelism Of The Cutting Deck; To Do A Check Of The Engine Oil Level; To Do A Check Of The Transmission Oil Level - Husqvarna R 214C Workshop Manual

4.8 To do a check of the parallelism of the
cutting deck
1. Make sure that the air pressure in the tires is correct.
Wheels on page 9 .
Refer to
2. Park the product on a level surface.
3. Lower the cutting deck to mow position.
4. Set the cutting height lever to the middle position.
5. Measure the distance between the ground and the
front and rear edges of the cutting deck. Make sure
that the rear edge is 2–4 mm (1/8") higher than the
front edge.

4.9 To do a check of the engine oil level

1. Park the product on level ground and stop the
engine.
2. Open the engine cover.
3. Loosen the dipstick and pull it out.
4. Clean the oil from the dipstick.
5. Put the dipstick back in and tighten it.
6. Loosen and pull the dipstick out and read the oil
level.
1592 - 002 - 11.02.2021
7. The oil level must be between the marks on the
dipstick. If the level is near the ADD mark, fill oil to
the FULL mark.
8. Fill the oil through the hole that the dipstick sits in.
Fill the oil slowly.
Technical data on page 49 for the
Note: Refer to
types of engine oil that we recommend. Do not mix
different types of oil.
9. Tighten the dipstick correctly before you start the
engine. Start and idle the engine for approximately
30 seconds. Stop the engine. Wait 30 seconds and
do a check of the oil level again.

4.10 To do a check of the transmission oil level

Note: Do the transmission oil check when the
transmission is cool.
1. Put the product on a horizontal surface.
2. Remove the screws, one on each side, and remove
the transmission cover.
Assembly - 11