Removing And Installing The Protection Cover - Siemens SIMOGEAR BA 2030 Operating Instructions Manual
Gearbox
Hide thumbs
Also See for SIMOGEAR BA 2030:
Table of Contents
Advertisement
Installation
4.8 Removing and installing the protection cover
Observe the correct mounting arrangement to minimize stress on shafts and bearings due to
lateral forces.
Correct
a
F
Figure 4-2
Procedure
1. Use either benzine or solvent to remove the anti-corrosion protection from the shaft ends
and flanges or remove the applied protective skin.
2. Fit the drive input and output elements to the shafts. Fasten the elements when necessary.
You have now fitted the input or output element.
4.8
Removing and installing the protection cover
The protection cover of the hollow shaft is delivered ready-fitted to the gearbox flange.
Dismantle the protection cover for installation of the output shaft.
The plastic protection cover of the hollow shaft is supplied loose as kit.
32
Hub
Force
Mounting arrangement for low stress on shafts and bearings
Incorrect
Operating Instructions, 07/2020, A5E50009094A/RS-AL
BA 2030 (2KJ4)
Advertisement
Table of Contents
