Topping Up With Oil - Siemens SIMOGEAR BA 2030 Operating Instructions Manual

Observe the symbols in the diagrams of the Mounting positions (Page 84):
Venting
Procedure
1. Unscrew the vent plug.
2. Fill the gearbox with fresh oil. Use a filler filter with mesh of max. 25 μm.
3. Check the oil level.
4. Top up the oil level if necessary and check it again.
5. Check the state of the sealing ring on the sealing element. If the sealing ring is damaged,
replace the sealing element with a new one.
6. After filling with oil, seal the gearbox immediately using the sealing element.
You have now filled up the gearbox with oil.
8.2.6

Topping up with oil

If the mounting position of the gearbox is changed or oil lost because of leakage, check the
oil level. If you notice oil escaping, locate the leak, and seal the affected area. Top up and
check the oil level.
At the time of going to print, the following types of oil are being used when the gearbox is
filled for the first time:
CLP ISO VG220: Fuchs Renolin CLP220
CLP ISO PG VG220: Fuchs Renolin PG220
CLP ISO PG VG460: Fuchs Renolin PG460
CLP ISO PAO VG68: Fuchs Renolin Unisyn CLP68
CLP ISO PAO VG220: Fuchs Renolin Unisyn CLP220
CLP ISO PAO VG460: Fuchs Renolin Unisyn CLP460
CLP ISO E VG220: Fuchs Plantogear S220
CLP ISO H1 VG100: Klüber Klübersynth UH1 6 100
CLP ISO H1 VG460: FUCHS CASSIDA FLUID GL 460
If, following agreement, the gearbox is filled at the factory with special lubricant for the
special applications referred to above, the lubricant must be shown on the rating plate.
BA 2030 (2KJ4)
Operating Instructions, 07/2020, A5E50009094A/RS-AL
Service and maintenance
8.2 Checking and changing lubricants
67