Checking And Changing Lubricants; General Safety Notes - Siemens SIMOGEAR BA 2030 Operating Instructions Manual

Service and maintenance

8.2 Checking and changing lubricants

Remedy
Carry out a complete inspection
of the geared motor.
Check the friction clutch and
adjust if necessary.
Check the coupling.
Check that fastening bolts on
gearboxes and add-on elements
are securely tightened. Check
that covers and plugs are secure-
ly fastened.
Change the roller bearing
grease.
Replace the bearing.
Check the rubber buffer of the
torque arms.
Check the hose of the oil expan-
sion unit.
Lubricate the XLplus and VLplus
heavy-duty bearing systems.
When using synthetic oils, the intervals can be doubled. The data specified is valid for an oil tem-
1)
perature of +80 °C. See the figure titled "Guide values for oil change intervals" for the intervals for
other temperatures.
8.2 Checking and changing lubricants
8.2.1

General safety notes

Danger of scalding from the hot oil emerging from the unit
Before starting any work wait until the oil has cooled down to below +30 °C.
Risk of slipping on oil
Remove any oil spillage immediately with an oil-binding agent in compliance with
environmental requirements.
60
WARNING
WARNING
Interval
Every 12 months.
After 500 hours, thereafter once
a year and after every blockage.
For the first time after 3 months. Please refer to the separate
After 3 hours, and then every 2
years.
When the oil is changed.
-
Every 6 months.
Check regularly; renew every 4
years at the latest.
-
Operating Instructions, 07/2020, A5E50009094A/RS-AL
Description of work
Inspecting the gearbox
(Page 78)
Observe the BA 2039 (2KJ4)
Operating Instructions.
operating instructions.
Checking the tightness of fas-
tening bolts (Page 77)
Change the roller bearing grease
(Page 68)
Replace bearings (Page 75)
Torque arms with shaft-
mounted gearboxes (Page 44)
Replacing the hose of the oil
expansion unit (Page 78)
Lubrication of the XLplus and
VLplus heavy-duty bearing sys-
tems (Page 72)
BA 2030 (2KJ4)