Hollow Shaft With Feather Key; Mounting The Hollow Shaft With Feather Key - Siemens SIMOGEAR BA 2030 Operating Instructions Manual

Installation
4.9 Installing and removing the shaft-mounted gearbox
4.9.2

Hollow shaft with feather key

4.9.2.1

Mounting the hollow shaft with feather key

*
①
②
③
④
⑤
Figure 4-5
Instead of the nut and threaded spindle shown in the diagram, other types of equipment
such as hydraulic lifting equipment may be used.
Procedure
1. Using benzine or a solvent, remove the anti-corrosion protection from the shaft extensions
and flanges.
2. Check the seats or edges of the hollow and machine shafts for damage. Contact Technical
Support if you notice any damage.
3. Apply the mounting paste provided ① to the machine shaft ⑧. Apply the paste uniformly.
Carefully wipe away the rest at the shaft sealing ring of the gearbox.
4. Fit the gearbox using the disk ⑤, threaded spindle ④ and nut ③. Support is provided by the
hollow shaft ②.
5. Replace the nut ③ and the threaded spindle ④ with a screw ⑨. Tighten the bolts ⑨ to the
specified torque.
6. Close the open hollow shaft extension using a sealing cap ⑩.
You have mounted the hollow shaft with feather key.
Table 4- 6
Thread size
Tightening torque [Nm]
36
Not included in the scope of supply
Machine shaft
Hollow shaft
Hexagon nut
Threaded spindle
Disk
Mounting the hollow shaft with feather key
Tightening torque for the screw
M5
5
⑥ Circlip
⑦ Feather key
⑧ Mounting paste
⑨ Bolt
⑩ Sealing caps
M6 M8 M10 M12
8 8 14 24
Operating Instructions, 07/2020, A5E50009094A/RS-AL
M16 M20 M24 M30
60 120 200 400
BA 2030 (2KJ4)