Siemens SIMOGEAR BA 2030 Operating Instructions Manual page 35
Gearbox
Hide thumbs
Also See for SIMOGEAR BA 2030:
Table of Contents
Advertisement
①
②
Figure 4-3
Procedure
Premounted protection cover
1. Release the screws ① and remove the protection cover ② together with the flat gasket or O-
ring ③.
2. Mount the output shaft.
3. Use a suitable cleaning agent to clean the contact surface of the protection cover ② on the
gearbox.
4. Ensure that the flat seal or the O-ring ③ is correctly seated.
5. Wet the bolts ① with medium-strength adhesive, e.g. Loctite 243.
6. Screw on the protection cover ②.
7. Protect all remaining bare areas with a suitable permanent anti-corrosive agent.
You have now installed the protection cover for operation.
BA 2030 (2KJ4)
Operating Instructions, 07/2020, A5E50009094A/RS-AL
Screw
Protection cover
Protection cover for hollow shaft
4.8 Removing and installing the protection cover
③
Flat seal/O-ring
④
Gearbox housing
Installation
33
Advertisement
Table of Contents
