Further Information On Device Configuration; Protection Of The Device Settings; Network Configuration - Honeywell SmartLine RM60 Handbook

SMARTLINE® RM60 (FMCW)
Data dependencies for the 20 mA settings of outputs 1 and 2
Output function
Level >4 mA Setting for Level
Volume >4 mA Setting for Volume
Mass >4 mA Setting for Mass
Distance >4 mA Setting for Distance
Ullage Volume >4 mA Setting for Ullage Volume
Ullage Mass >4 mA Setting for Ullage Mass
1 RO = Reference Offset (C1.10). TBO = Tank Bottom Offset (C.1.11).
2 BD = Blocking Distance (C.1.9). TBO = Tank Bottom Offset (C.1.11).
3 RO = Reference Offset (C1.10).

6.4 Further information on device configuration

6.4.1 Protection of the device settings

The Passwords Passwords Passwords menu lets you change the supervisor password. Passwords
How to change the supervisor password
• Go to Supervisor > Advanced setup > Device setup > Passwords > Supervisor Supervisor > Advanced setup > Device setup > Passwords > Supervisor Supervisor > Advanced setup > Device setup > Passwords > Supervisor. Supervisor > Advanced setup > Device setup > Passwords > Supervisor
• Type in the new 6-character password (push the 4 buttons in any sequence).
• Type in the new 6-character password again.
i If the second entry is not the same as the first, the device will display the error message
"Password mismatch". Push [> > > > ] and[ ] at the same time and type in the new 6-character
password again.
• Push [> > > > ] and [ ] (Esc) at the same time to go back to the "save settings" window.
• Select Save Save and push [^ ^ ^ ^ ]. Save Save
i The device will go back to operator mode.
INFORMATION!
Make a note of the password and keep it in a safe place. If you lose the password, please speak
or write to your supplier.

6.4.2 Network configuration

INFORMATION!
For more data, refer to Networks on page 38
The device uses HART® communication to send information to HART®-compatible equipment. It
can operate in either point-to-point or multidrop mode. The device will communicate in
multidrop mode if you change the HART® address of output 1.
34-VF-25-31 iss.4 GLO December 15 US
Minimum value
www.honeywell.com/ps
Maximum value
Tank Height + TBO + RO
Max. value in the volume table
Max. value in the mass table
Tank Height + TBO + RO
Max. value in the volume table
Max. value in the mass table
.
OPERATION
Default
Tank height +
1
TBO - BD
Max. value in
the volume
table
Max. value in
the mass table
Tank height +
1
RO
3
Max. value in
the volume
table
Max. value in
the mass table
6
2
63