Table of Contents
Advertisement
SMARTLINE® RM60 (FMCW)
Error Message
Peak and spectrum
Spectrum quality is bad
Empty spectrum is invalid
Plausible peak is not
available
Software error
Unable to load DSP firmware
34-VF-25-31 iss.4 GLO December 15 US
Error
Description
code
W
The quality of the spectrum is
poor. If this message is
temporarily shown, this will
not affect the performance of
the device. If this message is
continuously shown, the
measured values can be
incorrect. The error message
"Measurement is old" will
then be displayed. Possible
causes are internal silo
elements.
W
The Empty Spectrum stored
in the device does not agree
with the installation. If you
change the device
configuration (application
type, installation type, tank
height etc.), this message will
be displayed. The recorded
empty spectrum will not be
used by the device while this
error message is displayed.
W
The signal peak is not found
within the measuring window
that filters the signals
received by the antenna. The
measurement is not correct.
The device will automatically
increase this window to find
the correct signal.
E
The DSP Firmware did not
download correctly to the
DSP board.
www.honeywell.com/ps
OPERATION
Corrective action
Check the device, silo and the
process. Reconfigure the
device and record a new
empty spectrum. Follow the
instructions on page 68. If
necessary, contact the
supplier.
Check the device, silo and the
process. Reconfigure the
device and record a new
empty spectrum. Follow the
instructions on page 68. If
necessary, contact the
supplier.
Check the device, silo and the
process. Reconfigure the
device and record a new
empty spectrum. Follow the
instructions on page 68. If
necessary, contact the
supplier.
Restart the device. If the
problem continues, contact
the supplier or replace the
electronics block. For more
Replacement of
data, refer to
the complete electronic
module
on page 80.
6
75
Advertisement
Table of Contents
