Operation; User Modes; Operator Mode - Honeywell SmartLine RM60 Handbook

SMARTLINE® RM60 (FMCW)

6.1 User modes

Operator Operator
Operator Operator
Supervisor Supervisor Supervisor Supervisor

6.2 Operator mode

The operator can choose what information to display.
This section shows you:
• What each button does in operator mode.
• What special function each button has if it is pressed for more than 1 second.
• How to move from one screen of information to another.
Some data (volume, mass etc.) will only be available if the device is correctly configured by the
supervisor, as described below.
Functions of keypad buttons in operator mode
Keypad button
1 Value, value and picture, or value and bar graph
2 Push this button for 1 second
3 Push this button after the selection of the signal screen. For more data, refer to "Operation: How to make the device
follow the correct level or interface signal".
4 Level, distance, volume etc.
5 Push this button for 3 seconds. Push the button again and it will go back to the original language.
34-VF-25-31 iss.4 GLO December 15 US
This mode displays measurement data. For more data, refer to
mode on page 45.
Use this mode to view parameters, commission the device, create tables
for volume or mass measurement, change critical values to measure in
difficult process conditions. To get access to the supervisor menu, refer to
Protection of the device settings
Function description
refer to
Description Normal function
Right Change display style
—
Enter
Down Change measurement parameter
4
Up Change measurement parameter
4
—
Esc (Escape)
www.honeywell.com/ps

OPERATION

on page 63. For more data on menu items,
on page 53.
"Hot key" function
Enter program mode
1
Enter signal screen editing mode
3
The screen shown at this time
becomes the default screen
Display language will change to
English
5
—
6
Operator
2
2
45