Table of Contents
Advertisement
INSTALLATION
3
• Attach the antenna extensions 1 below the flange.
• Attach the antenna 2.
• Make sure the antenna extensions are fully engaged.
• Use a 3 mm Allen wrench to tighten the locking screws 3.
• If you attach more or less extensions than were initially ordered, change the antenna
extension value in Supervisor
Antenna Extension.
Antenna Extension
Antenna Extension
Antenna Extension
i
Use the display screen or HART
antenna extension length × number of extensions.
• If you changed the antenna extension value in Supervisor
distance value. Go to Supervisor > Advanced setup > Installation > Blocking Distance
Use the display screen or HART
i
distance = antenna length + (antenna extension length × number of extensions) + 0.3 m /
12¨.
Drop antenna - antenna extensions
Figure 3-13: Drop antenna - how to attach antenna extensions
INFORMATION!
Drop antenna: Antenna extensions can only be attached below flanges without the PP/PTFE
Drop antenna:
Drop antenna:
Drop antenna:
flange plate option
CAUTION!
Drop antenna: Make sure that there are not more than 5 antenna extensions attached to a device
Drop antenna:
Drop antenna:
Drop antenna:
with a Drop antenna. If there are more than 5 antenna extensions, the device will not measure
correctly.
Make sure that you put an O-ring 4 into the groove at the top of each antenna extension.
Equipment needed (not supplied):
• Torque wrench 200 Nm (for the H30 head of the Drop antenna sub-assembly)
• 3 mm Allen wrench
• Remove the O-rings from the plastic sachet supplied with the device. Put an O-ring 4 into the
groove at the top of each antenna extension.
• Attach the antenna extensions 1 below the flange.
• Attach the antenna 2. Tighten the antenna with a torque wrench to a torque of 200 Nm
±10 Nm.
• Make sure the antenna extensions are fully engaged.
• Use a 3 mm Allen wrench to tighten the locking screws 3.
• If you attach more or less extensions than were initially ordered, change the antenna
extension value in Supervisor
Antenna Extension.
Antenna Extension
Antenna Extension
Antenna Extension
30
Supervisor mode. Go to Supervisor > Advanced setup > Installation >
Supervisor
Supervisor
®
communication (PACTware™). Antenna extension =
Supervisor > Advanced setup > Installation > Blocking Distance.
Supervisor > Advanced setup > Installation > Blocking Distance
Supervisor > Advanced setup > Installation > Blocking Distance
®
communication (PACTware™). Minimum blocking
Supervisor mode. Go to Supervisor > Advanced setup > Installation >
Supervisor
Supervisor
www.honeywell.com/ps
SMARTLINE® RM60 (FMCW)
Supervisor > Advanced setup > Installation >
Supervisor > Advanced setup > Installation >
Supervisor > Advanced setup > Installation >
Supervisor mode, also change the blocking
Supervisor
Supervisor
Supervisor > Advanced setup > Installation >
Supervisor > Advanced setup > Installation >
Supervisor > Advanced setup > Installation >
34-VF-25-31 iss.4 GLO December 15 US
Advertisement
Table of Contents
