Table of Contents
Advertisement
INSTALLATION
3
3.7.2 How to install a device with a threaded connection
Equipment needed:
• Device
• Gasket for G 1½ connection (not supplied)
• 50 mm / 2¨ wrench (not supplied)
Requirements for threaded connections
Figure 3-10: Threaded connection
If the antenna is smaller than the process connection:
• Make sure the silo connection is level.
• Make sure that you use the applicable gasket for the connection dimensions and the process.
• Align the gasket correctly.
• Lower the antenna carefully into the silo.
• Turn the threaded connection on the housing to attach the device to the process connection.
• Tighten the connection.
i
Refer to local rules and regulations for the correct torque to apply to the connection.
Figure 3-11: How to attach the device if the antenna is larger than the process connection
28
www.honeywell.com/ps
SMARTLINE® RM60 (FMCW)
34-VF-25-31 iss.4 GLO December 15 US
Advertisement
Table of Contents
