How To Turn Or Remove The Signal Converter - Honeywell SmartLine RM60 Handbook

SMARTLINE® RM60 (FMCW)
i Use the display screen or HART
antenna extension length × number of extensions.
• If you changed the antenna extension value in Supervisor
distance value. Go to Supervisor > Advanced setup > Installation > Blocking Distance
i Use the display screen or HART
distance = antenna length + (antenna extension length × number of extensions) + 0.3 m /
12¨.

3.7.4 How to turn or remove the signal converter

INFORMATION!
The converter turns 360
under process conditions.
Figure 3-14: How to turn or remove the signal converter
1 Tool: 5 mm Allen wrench (not supplied)
2 Cover for the wave guide hole on top of the process connection assembly (not supplied)
CAUTION!
If you remove the converter, put a cover on the wave guide hole on top of the process connection
assembly.
When the converter is attached to the process connection assembly, tighten the lock screw.
34-VF-25-31 iss.4 GLO December 15 US
®
communication (PACTware™). Antenna extension =
Supervisor > Advanced setup > Installation > Blocking Distance.
Supervisor > Advanced setup > Installation > Blocking Distance Supervisor > Advanced setup > Installation > Blocking Distance
®
communication (PACTware™). Minimum blocking
° . The converter can be removed from the process connection assembly
www.honeywell.com/ps
INSTALLATION
Supervisor mode, also change the blocking
Supervisor Supervisor
3
31