2N NetSpeaker Complete Manual page 85

Soffit Flush Mounting
No additional accessories are required for flush mounting into a plasterboard ceiling
(soffit). Just put the device into a pre-drilled hole and fit it with four mounting clips.
Remove the loudspeaker protecting grid using a narrow screwdriver / needle /
tweezers to get access to the fixing screws. You can use the enclosed paper template
for drilling the soffit hole. Refer to the figure below for recommended dimensions of the
hole.
It is very easy to connect
avoid equipment damage or electrical injury:
1. Connect the digital input and output.
2. Insert the microSD card.
3. Connect the UTP cable.
Connect a 12V power supply (unless PoE is used). This variant
have connected two loudspeakers, but they play in mono mode.
®
2N TELEKOMUNIKACE a.s., www.2n.cz
Figure: Mounting Holes
2N ® NetSpeaker electrically. Follow the steps below to
2N® NetSpeaker may
85