2N NetSpeaker Complete Manual page 60

help
set
(parameter)(value)
get (parameter)
print
save
exit
reboot
List of Parameters
activemode
searchmode
volume
domain
descr
dhcpclient: This parameter enables/disables automatic obtaining of network
parameter settings from the DHCP server in the LAN.
®
2N TELEKOMUNIKACE a.s., www.2n.cz
This command displays the list of available commands.
This command sets the parameter to a selected value.
Example: set dhcpclient 1
This command displays the current parameter value.
Example: get dhcpclient
This command writes out all parameters including values.
This command saves all parameter changes into the 2N
NetSpeaker
This command quits connection with the Telnet server.
This command resets the equipment.
®
2N NetSpeaker is connecting actively to the
Remember to set the srvipadr and srvport parameters correctly if 1 is
selected.
Setting options:
®
2N NetSpeaker
0
®
by the 2N NetSpeaker Server
®
2N NetSpeaker
1
®
by 2N NetSpeaker
Default setting: 1
®
2N NetSpeaker is searching for the
network and uses the Server's domain.
Setting options:
Searchmode is disabled
0
Searchmode is enabled
1
Default setting: 1
Volume settings for 2N
the maximum value.
Default setting: 1024
Domain settings used by
Default setting:
Descr is an optional parameter describing
to use any string.
Default setting: MAC address
memory.
passive mode. The server connection is initiated
.
active mode. The server connection is initiated
.
®
2N
®
NetSpeaker , where 0 is the minimum and 4096
®
2N NetSpeaker for communication.
2N
®
2N NetSpeaker Server
NetSpeaker Server
®
NetSpeaker . It is possible
®
.
in the
60