2N NetSpeaker Complete Manual page 21

Generic RTP Output
Generic RTP output enables sending of the audio from the 2N
to all the devices that support audio via the RTP protocol with codec G711, L16. Codec
is defined in this output. The audio stream will be sent to the defined IP address and
port. The so-defined output can then be used as an audio output from the session with
which the RTP output must be interconnected. A l
function of the
Properties of RTP Destinations
This section is devoted to RTP destinations.
Destination name – this parameter shows the name of the RTP destination and
can be changed.
Audio codec –
the following 4 options:
IP Address – set the multicast IP address.
Port – set the port.
TTL − set the TTL (Time to Live) for multicast packets: -1 means system default
and we recommend you not to change this parameter. This parameter may cause
network overload if not used in cooperation with a network specialist.
Licence owned – shows if a valid licence was successfully added.
®
2N TELEKOMUNIKACE a.s., www.2n.cz
RTP destinations
Figure: RTP Destination Settings
allows you to select the required audio codec. You can choose one of
G711 u-Law
G711 A-Law
Liner PCM 16 bit Stereo
Liner PCM 16 bit Mono
icence
.
®
NetSpeaker Server
is necessary for a proper
21