2N NetSpeaker Complete Manual page 13

The created session is ready for broadcasting to destination(s). If no more parameters
are needed, simply click
playing. See the figure at the very end for two types of sources. The common bar
contains volume control settings.
Session Control and Launch
Click ON
The figure below also shows additional session controls.
Balance – set balance for the right/left channel.
Listening in – enable this parameter to listen to remote destinations locally.
Volume – set the main session volume.
Sound activation/deactivation – enable/disable sound for the active session.
Destinations − list of used destinations and zones.
Additional Session Setting Options
Besides the basic settings mentioned in the Session Creation and Preparation for
Playing above, there are additional session settings such as
situated in the right–hand upper corner.
®
2N TELEKOMUNIKACE a.s., www.2n.cz
Figure: Adding of Sources and Destinations to Session
PLAY
in the Session control section to launch a session; refer to the figure below.
Figure: Session Control
and the added Sessions or another source will start
Priority Channel , or Fade
13