2N NetSpeaker Complete Manual page 67

MONO mode.
Headphone/External Amplifier Connection
®
2N NetSpeaker
3.5mm jack is available on the front panel.
Digital Input and Output
®
2N NetSpeaker
amplifier/alarm/activation. The
and allows for switching of up to 24V/1A AC/DC loads. Program the output either as
N/O (normally open) or N/C (normally closed).
Warning
®
2N NetSpeaker
movement or other applications. This input is available on the LOGIC IN terminal. From
5 to 24V DC voltage can be applied to the input against the ground terminal marked
DC IN –. In the case of an external button, the DC IN + terminal can be used, see the
figure below.
Warning
®
2N TELEKOMUNIKACE a.s., www.2n.cz
is equipped with a headphone/external amplifier connector. The
is equipped with a relay switch for light signalling/external
output
Do not exceed the upper voltage and current limits to avoid irreversible
damage of the equipment.
is equipped with a digital
Do not exceed the maximum voltage values (24V) applied to the LOGIC
IN input to avoid irreversible damage of the equipment.
Figure: 2N
is available on terminals marked LOGIC OUT
input for an optional button, sensor of
® NetSpeaker - Logical Input
67