Troubleshooting - 2N NetSpeaker Complete Manual

Troubleshooting

®
2N NetSpeaker is not displayed in the Destinations
Make sure that that DHCP is enabled for your network, or you must know the IP
address, subnet mask and gateway which can be assigned to
When the other LAN devices receive the IP address automatically, 2N
NetSpeaker
setting then automatically assigns IP addresses only to the known/registered LAN
devices based on their MAC addresses.
Firewall may also block the 2N NetSpeaker connection
When
t he active firewall
®
2N NetSpeaker sound is jerky
You
intercommunicating components
value is 40 ms, which is typically sufficient for local area networks (LAN), or you
can increase the value to up to the maximum of 10,000 ms. You can also set the
Sound path delay
or
Missing licence for multiple 2N NetSpeaker unit connection
An 800-hour trial licence for all licensed features is started automatically upon
every
count of RTP destinations generated is unlimited for t
trial licence expires, the count of
more units may be connected to the
licence to connect more units than 5.
®
2N NetMic is not visible in Destination
2N
®
2N TELEKOMUNIKACE a.s., www.2n.cz
For the most frequently asked questions refer to
may not get it due to restrictions set by the IT department. This
®
2N NetSpeaker
may not permit such connection.
can set the Sound path delay
for the other system applications:
®
2N NetSpeaker Virtual Sound Card
new installation . The count of
®
NetMic is not displayed in
®
disconnects and then tries to reconnect to the same port,
on the Destinations & Zones
in the respective application settings.
®
®
2N NetSpeaker
®
2N NetSpeaker
®
2N NetSpeaker Server
&
Destination & Zones
faq.2n.cz .
& Zones menu
®
2N
®
for 2N NetSpeaker
tab. The default
®
2N NetSpeaker Console
units connected and the
he first 800 hours
units is limited to 5 and no
. Purchase a new
Zones
but in Audio sources
NetSpeaker .
®
and all
. When the
.
109