2N NetSpeaker Complete Manual page 54

®
2N NetSpeaker Connections
Set the connection parameters for
the 2N
®
2N NetSpeaker.
Parameters:
Connection timeout – define the time interval between the connection making
attempts.
IP address – set the
IP port – set the
Automatic firmware upgrade – disable the
upgrade.
®
2N NetSpeaker Scanner
Use the
settings in the network. All speakers available in the network are displayed to the left.
Having selected a speaker, you can change its parameters in the right–hand part to
make it connect to the
the NetSpeaker connections
Caution:
®
2N TELEKOMUNIKACE a.s., www.2n.cz
®
NetSpeaker scanner below).
2N
®
2N
Figure: Connection Parameters
®
2N NetSpeaker scanner to search for the
®
2N
If there is a yellow-highlighted NetSpeaker in the scanner, please check
the domain (both on the server and end device sides), or
check the license for excessive count of devices for trial use.
®
2N NetSpeakers
Save the parameters to establish connection to
®
NetSpeaker IP address.
NetSpeaker port; 6998 is the default value.
NetSpeaker Server
parameters.
in the passive mode (refer to
®
2N NetSpeaker
®
2N NetSpeaker
automatically (active mode), or using
firmware
units and their
54