■ Connecting the speaker cable
1
Remove approximately 10 mm of insulation
from the end of each speaker cable and then
twist the exposed wires of the cable together
to prevent short circuits.
10 mm
2
Loosen the knob.
Red: positive (+)
Black: negative (–)
3
Insert one bare wire into the hole on the side
of each terminal.
Red: positive (+)
Black: negative (–)
4
Tighten the knob to secure the wire.
Red: positive (+)
Black: negative (–)
■ Connecting to the PRESENCE/ZONE2
speaker terminals
Connect presence speakers to these terminals.
y
You can also use these terminals to connect the Zone 2 speakers
(see page 97).
1
Open the tab.
2
Insert one bare wire into the hole on the side
of each terminal.
3
Close the tab to secure the wire.
CONNECTIONS
15