Changing Source Names In The Display Window - Yamaha SR-PGB54P Owner's Manual

Remote control features
Press F SETUP again to exit the setup
7
menu.
Notes
• "ERROR" appears in the display window (4) on the remote
control if you press a button not indicated in the respective step,
or when you press more than one button simultaneously.
• This remote control can learn approximately 200 functions.
However, depending on the signals learned, "FULL" may
appear in the display before you program 200 functions. In this
case, clear unnecessary programmed functions to make room
for further learning (page 89).
• Learning may not be possible in the following cases:
– when the batteries in the remote control for this unit or other
components are weak.
– when the remote control is exposed to direct sunlight.
– when the function to be programmed is continuous or
uncommon.
Changing source names in the
display window
You can change the name of the control area (input
source) that appears in the display window (4) on the
remote control.
1
Set the operation mode selector to
ESOURCE and then press an input selector
button (3) to select the desired control area.
2
Press FSETUP using a ballpoint pen or
similar object.
"SETUP" appears in the display window.
3
Press 8k / n repeatedly to select "RNAME"
and then press 8ENTER.
4
Press 8k / n repeatedly to select 3-letter
name or 5-letter name you want to edit and
then press 8ENTER.
Each control area has both 3-letter name and 5-letter
name. You can rename the 3-letter name and 5-letter
name independently.
3-letter name
BD
86
En
5
6
7
Note
"ERROR" appears in the display window (4) on the remote
control if you press a button not indicated in the respective step,
or when you press more than one button simultaneously.
5-letter name
BD/HD
Edit the name of the control area.
To locate the position to edit , press 8l / h.
To select a character, press 8k / n.
BD/HD
y
Press 8k to change the character in the following order,
or press 8n to go in the reverse order: A to Z, a to z, 0 to
9, space, symbols (–, +, /, :).
Press 8ENTER to set the new name.
"OK" appears in the display window (4) on the
remote control if renaming was successful.
y
When you want to rename the another control area, press
the input selector button (3) or 5SELECT l / h
repeatedly to select the desired control area and then press
8ENTER and then carry out the operations of steps 4
through 6.
Press F SETUP again to exit the setup
menu.