Printout Parameters (Overview) - Sartorius LA Reference Series Operating Instructions Manual

Configuration

Printout Parameters (Overview)

ο factory setting
√ user-defined setting
Setup Application-
Printout defined output
Automatic
output of
displayed value
Output to
interface port
Line format
ISO/GLP/GMP
printout
Identification
Factory settings:
only
printout
1
) = when the balance is used in legal metrology, this setting may be configured for control purposes only; printout of values is not permitted
2
) = Autoprint when load change is >10 d and stability is reached: no printout until residual difference in load value >5 d
3
) = to enable automatic output of the displayed value, the corresponding option ("Automatic output of displayed value" must be activated
here, under "Stability parameter"
4
) = These settings may not be changed on verified balances
Stability parameter
Print on request,
then tare
Auto print upon
initialization
(of the application)
Configured printout
FlexPrint
Stability parameter
3 )
Stop auto print
Time-dependent
auto print
Serial communication
(PERIPHERALS)
For raw data (16 characters)
ο For other apps/
GLP (22 characters)
ο Off
Only for calibration/adjustment
Always on
Lot ID (L ID):
ID1:
ID2:
ID3:
ID4:
No
Yes
1
Without stability )
ο With stability
ο Off
On
ο Off
All values
Only main values
See separate chapter starting on the next page
ο Off
On
ο Without stability
At stability
Automatic after weight change
Use print key r
ο Not possible
ο 1 display update
2 display updates
4
10 display updates )
4
100 display updates )
ο Application-defined output
Automatic output of displayed value
Enter 20 characters max
ID1
ID2
ID3
ID4
2 )
31