RS 125
•
Release the tie (2).
NOTE Place some paper under the fitting to collect any oil
spillage.
•
Disconnect the oil tubes and block them off.
•
Disconnect the throttle cable at the mixture oil pump
end; see
7.3.2.
•
Perform the first five steps of the procedure described
at paragraph
5.5.1
•
Disconnect the clutch cable at the engine end only; see
7.3.4.
•
Remove the battery and battery box mount together;
see
7.2.1.
•
Release and remove the two screws (3) and remove
the sprocket cover.
•
Remove the circlip.
NOTE Slacken the drive chain to aid removal of the chain
sprocket.
•
Slide the chain sprocket and the drive chain off the
shaft.
•
Disconnect the following electrical connectors in the
order:
-
Starter motor (4) – release the wiring from the ties.
ENGINE
6 - 7