RS 125
7.2.5.
REMOVING THE LEFT-HAND LIGHT DIP
SWITCH
Read
1.2.1
carefully.
TORQUE WRENCH SETTINGS
Screws (2)
•
Lift the fuel tank; see
•
Disconnect the connector (1) of the left-hand light dip
switch.
•
Release and remove the two screws (2) securing the
two shells at the bottom end.
•
Separate the two shells.
WARNING
On refitting, position the bottom shell first,
making sure the locating peg becomes fully
seated into the handlebar hole.
•
Disconnect the cold-start cable (3).
•
Release the wiring from the clips and remove the left-
hand light dip switch.
3 Nm (0.3 kgm)
2.9.1.
CHASSIS
7 - 29