CHASSIS
7.11.4.
REASSEMBLING THE SWINGING ARM
Read
1.2.1
carefully.
NOTE Change both needle roller bearings.
•
Clean all components of the swinging arm articulated
connection and apply lithium grease.
•
Install two new needle roller bearings (1) using a drift
with adequate diameter. The bearings must be centred
axially in the bearing housing.
•
Position the four O-rings (2).
•
Slide the two bushes of the needle roller bearings (3)
into the swinging arm.
•
Position the outer plastic washers (4).
7 - 102
4
1
2
3
RS 125
1
4
2