APRILIA RS 125 Manual page 38

ROUTINE MAINTENANCE
VBAT (battery voltage)
•
If the push button
voltage expressed in volt (1) appears on the display.
•
The recharge circuit functions correctly if at 4000 rpm
the battery voltage with low beam on is included
between 13 and 15 V.
•
The current hour (2) is shown in the lower part of the
display.
TIME (hour / minutes setting)
•
If the push button
hour and minutes are displayed (1).
•
To modify the settings, proceed as follows:
•
Press the key , the hour segments start blinking.
•
Press key , to increase the value.
•
To set the minutes setting, press key
segments start blinking.
•
Press key , to increase the value
•
To store the hour and minutes settings, proceed as
follows.
•
Press the center key
LAP TIME (chronometer)
•
When the function key
the "LAP TIME" function (1) is displayed. This function
makes it possible to measure the time per lap with the
vehicle on a racetrack or to store the data, in such a
way as to be able to consult them successively.
"LAP TIME" function instructions for use (only in case of
competitions in private areas).
•
To operate the chronometer, press the key
•
The wording "L" (Lap) will blink on the display.
•
To start timing, press the "LAP" push button (2) on the
left handlebar.
•
To display the lap time, press the push button "LAP" (2)
again.
•
The "LAP" push button (2) is not enabled for 15
seconds and the last time stored is shown on the
display, after which, the chronometer with the current
timing is displayed.
•
To leave the chronometer function, press key
NOTE It is possible to store max. 10 times. The "L 10" time
will be displayed as the list time measured.
2 - 8
is pressed once more, the battery
is pressed for the third time, the
, the minute
.
is pressed for the fourth time,
.
.
1
2
1
1
RS 125
2