APRILIA RS 125 Manual page 58

ROUTINE MAINTENANCE
•
Use the special wrench (5) to loosen the inner nut (6).
•
Fit a flat screwdriver into the special wrench (5) and
fully screw the adjuster (7).
•
Loosen the adjuster (7) by half of a turn, namely 3 to 4
mm of the lever travel (8).
•
Keep the adjuster (7) locked using the flat screwdriver,
turn the special wrench (5) and tighten the inner nut
(6).
•
Screw the cap (4).
•
Check the clutch lever end free play (10 to 15 mm).
•
Refit the left side fairing.
•
Start the engine.
•
Pull the clutch lever fully and engage the first gear.
Make sure that the engine does not stop and that the vehicle
does not tend to move, or that the clutch does not "slip"
during acceleration or running.
NOTE Check that the clutch cable is in good conditions: the
sheaths should be free from squeezing or wear.
•
To avoid early wear or corrosion, lubricate the clutch
cable with suitable lubricant at regular intervals, see
1.8.1
2 - 28
8
RS 125
6
7
5