Attaching The Controller And Sensor Head Connection Cable; Removing The Controller And Sensor Head Connection Cable - Panasonic HG-S Series User Manual

3-4-3 Attaching the Controller and Sensor Head Connection Cable

Insert the controller connector on the sensor head connection cable into the connector for the
sensor head connection cable on the controller.
Insert the connector firmly. Risk of sensor head or controller damage if not completely connected.

3-4-4 Removing the Controller and Sensor Head Connection Cable

Grasp the controller, and while pressing on the lock release lever on the controller connector
of the sensor head connection cable, pull toward you to disconnect.
If you attempt to disconnect the cable by pulling it without pressing the lock release lever,
cable wire breakage and connector damage may occur.
© Panasonic Industrial Devices SUNX Co., Ltd. 2016
SEN TRONIC
AG
Produkte, Support und Service
Insert
Lock release lever
Pull out
Rugghölzli 2
CH - 5453 Busslingen
INSTALLATION AND CONNECTIONS
Tel. +41 (0)56 222 38 18
Fax +41 (0)56 222 10 12
3-9
mailbox@sentronic.com
www.sentronic.com