C
3
HAPTER
MOUNT THE AUTOBOOM VALVE
ADJUSTING INSTALLED AUTOBOOM VALVE
FIGURE 1. Hydraulic Valve Before AutoBoom Installation
Before
Strip this
Surface
1. Strip the factory paint from the top of the existing hydraulic valve using a chemical approved for paint removal.
IMPORTANT:
Do not scrape the paint from the hydraulic valve. Scraping the paint may cause damage to the valve.
2. Remove the hydraulic test port fitting and Allen plugs from the existing hydraulic valve.
NOTE:
The test port fitting will be installed on the AutoBoom hydraulic valve later in the procedure. Protect
the test port fitting from dust and debris to avoid contamination of the hydraulic system.
3. Clean any remaining paint from the existing hydraulic valve, taking care to prevent paint chips from entering
the open hydraulic ports.
FIGURE 2. O-Rings Placed on the Machine Hydraulic Valve
10
Hydraulic
Test Port
Fitting
Allen
Plugs
AutoBoom® XRT Installation Manual for AGCO RoGator
After