Installation For Machines With Existing Hydraulic Valve - Raven AutoBoom XRT Installation Manual

4. Install 9/16" ID Buna-N O-rings (P/N 219-0001-015) in the open ports of the hydraulic valve.
NOTE: Use grease or petroleum jelly to hold the O-rings in place during the AutoBoom valve installation,
taking care to avoid contamination of the inside of the open ports.
5. Blow the hydraulic port threads of any excess oil.
6. Clean excess oil, grease, and debris from the top of the hydraulic valve.
7. Clean excess hydraulic fluid from the AutoBoom valve (P/N 334-0235-004).
8. Install the supplied hex bolts in the AutoBoom valve, placing the shorter bolt in the cut-out section of the
AutoBoom valve.
FIGURE 3. Hydraulic Valve without Needle Valves

INSTALLATION FOR MACHINES WITH EXISTING HYDRAULIC VALVE

On machines with existing AutoBoom valves, back the existing needle valves out completely then tighten the jam
nut.
FIGURE 4. AutoBoom Valve Mounted to the Hydraulic Valve
Needle
Valves
9. Carefully place the AutoBoom valve on the existing hydraulic valve, positioning it so that the cut-out section
faces the accumulator.
10. Alternately tighten each bolt a small amount to a maximum of 15-20 ft. lbs. per bolt.
11. Install the hydraulic test fitting in Port GP of the AutoBoom valve.
016-0237-002 Rev. A
HYDRAULIC SYSTEM INSTALLATION
11