Mount The Rs1; For Non-Autoguide Machines - Raven RS1 Installation Manual

Challenger mt 7xx & 8xx c/d/e

Hide thumbs Also See for RS1:

Table of Contents

CHAPTER 3

MOUNT THE RS1™

1. Insert the two tabs on the RS1 mounting bracket into the roof bracket slot with the sloped edge facing forward.

FIGURE 3. Roof Bracket

2. Connect the RS1 12-pin connector and the 12-pin round connector on the cab using the RS1 AGCO cable (P/N

115-4010-116).

1. Remove the bolts on top of the roof and along the perimeter of the bottom lip of the roof to remove the roof

cap.

2. Lift the cap from the front left side. Use a block to keep the roof open.

3. Locate the 12-pin connector labeled "TOP DOCK INTERFACE."

FIGURE 4. TOP DOCK INTERFACE Connector

RS1™ Installation Manual for Challenger MT 7XX & 8XX C/D/E

Table of Contents