Tilt Sensor Installation - Raven AutoBoom XRT Installation Manual

2. Install the height stop sensor assembly to the bracket in the position shown in Figure 16 on page 28.
3. Connect the 115-0235-041 cable to the height stop sensor.
4. Use the provided U-bolts to install the center rack position target below the center rack height sensor.
BOOM PROXIMITY SENSOR INSTALLATION
1. Install the proximity sensor assembly for the left side to the bracket as shown (mirrored for the right side) in
Figure 17, "Small Tree Proximity Sensor," on page 29 and secure with panel nuts.
FIGURE 17. Small Tree Proximity Sensor
2. Connect the 115-0235-040 cable to the proximity sensor.
3. Use the provided U-bolts to install the boom proximity sensor bracket to the center rack cross tube near the
left boom pivot as shown in Figure 18, "Boom Proximity Sensor Bracket," on page 29.
FIGURE 18. Boom Proximity Sensor Bracket
NOTE: The proximity sensor must be mounted so there is no more than 1/2 inch [1.27 cm] of clearance when
the booms are folded.
4. Repeat step 1 through step 3 for the right boom with the remaining proximity sensor and bracket.
016-0237-002 Rev. A
SENSOR INSTALLATION
29