Installation Overview; Hydraulic Fittings - Raven AutoBoom XRT Installation Manual

INSTALLATION OVERVIEW

The image below shows approximate installation locations for the sensor and nodes. Depending on machine
configuration and desired performance some of the sensors and dampers may not be installed.
FIGURE 2. Example Component Locations
Outer
Sensor
For additional information on the component installation, refer to the:
• rotary sensor installation instructions in "Center Rack Installation for Large Tree" on page 22 or "Center Rack
Installation for Small Tree" on page 26.
• variable damper installation instructions in "Damper Installation" on page 12.
• REM node installation instructions in "ABM and REM Node Installation" on page 31.
• ABM node installation instructions in "ABM and REM Node Installation" on page 31.
• tilt sensor installation instructions in "Mount the Boom Sensors" on page 19.
• outer sensor installation information in "Mount the Boom Sensors" on page 19.
• inner sensor installation information in "Mount the Boom Sensors" on page 19.
• center sensor installation instructions in "Mount the Center Sensor" on page 21.

HYDRAULIC FITTINGS

This manual may reference the following types of hydraulic fittings:
• SAE O-ring fittings
• ORFS (O-Ring Face Seal) fittings
• JIC fittings
SAE O-Ring Fittings
016-0237-002 Rev. A
Rotary Sensor and
Variable Damper
Center
Sensor
Inner
Sensor
ORFS Fittings
REM and ABM Node (Near
Electrical Box)
Variable Damper
Inner
Sensor
JIC Fitting
INTRODUCTION
Outer
Sensor
7